How To Install Flush Mount Rod Holders On Kayak?

To install a flush mount fishing rod holder on a sit-on-top kayak, use marine adhesive and a bead around the oval. Place the rod holder into the oval and press down onto the kayak. Use a hand screw driver to place and tighten the screws, being careful not to overtighten them. Flush mount rod holders are designed to be installed directly into the kayak’s hull, providing a sleek and seamless look. They are ideal for anglers looking for a permanent and secure mounting solution, keeping their fishing rods stable while allowing easy access during your fishing trip.

Installing a flush mount rod holder requires drilling a hole into the kayak that is the same width as the rod holder. This usually requires a hole drill bit or hole saw that attaches to your drill to create holes. Before installing a flush mount, read and understand these directions before drilling any holes in your boat.

Flush mount rod holders are most often installed behind the seat and ahead of the cockpit. Before installing a flush mount, measure the space below the deck to ensure it will accommodate the rod holder. The easiest way to determine this is to turn the base over and see if it can accommodate the base.

Installing a flush mount rod holder on a kayak can be a bit of a challenge if you have never done it before. However, this comprehensive overview can help you make the process easier.

Using a hole saw, carefully carve the hole into an ellipse so that it will allow enough room for the rod holder to fit flush with the deck. Drill out screw holes through foam on the rod holder using a 1364 drill bit. Insert the rod holder and mark screw holes. Remove the rod holder and drill holes using a 38 drill bit.

The most common place to install flush mount rod holders is behind the cockpit. The hardest part is deciding what sort of angle you want to put on them. Flush mount holders can be added by the user, but require drilling a large-diameter hole in the hull. Always measure to ensure there is room.