How To Clean A Finis Snorkel?

This video explains how to clean the purge valve on the Swimmers Snorkels. To purchase a FINIS Snorkel, visit http://www.finisinc.comequipment. The Snorkel features a purge valve that is easy to remove and clean. To clean the purge valve, squeeze the mouthpiece while slipping the seal’s lip away from the valve. Once removed, clean the purge valve with warm, soapy water.

There are two basic ways to keep your snorkel in relatively pristine condition:

1. Put it in the washing machine. If you’re hesitant to throw it in the dishwasher, you can wash it out with warm, soapy water and a long, thin brush or towel wrapped around a thin stick to clean the inside of the breathing tube. If you have the model with the filter, remove it first, but otherwise, the snorkel can go in, mouth piece and all.

To remove the purge valve from the Swimmers Snorkel, pinch the silicone retaining tube just above the hard plastic purge valve. Rinse your snorkel with clean water after every swim. When you get home, always take your snorkel out of your backpack and let it dry thoroughly.

How to clear a purge valve snorkel?

So it is clean from any debris. Place the purge valve back through the circular housing pull to make sure it is secure.

How do you sterilize a snorkel mouthpiece?

How do you sterilize a snorkel mouthpiece?. Remove the mouthpeice and put in dishwasher or drop in a cup with a teaspoon of bleach. Let sit for at least minutes. If the mouthpiece cannot be removed immerse the entire snorkel in a 1% bleach solution for at least 2 minutes. Clean with soap and warm water first if it’s especially dirty.

Can you put snorkel gear in the dishwasher?. You can but do not use the heated dry function as the heat may cause the thermoplastics to warp.

How do you disinfect a mask and snorkel?. Immerse the entire snorkel in a 1% bleach solution for at least 2 minutes. Clean with soap and warm water first if it’s especially dirty.

How do I clean my Finis snorkel?

About once a month, (depending on usage) you can also submerge your snorkel in hot soapy water with a few drops of bleach and rinse with fresh water. It is also safe to run the snorkel, without the head bracket, through a wash in the top rack of the dishwasher.

Is it necessary to always clean your snorkels after using why?

Snorkels. Cleaning your snorkel is very important since you can breathe in debris trapped in the tube, and also because the mouthpiece has several nooks where bacteria can grow. Rinsing in fresh water helps, but we recommend using dish detergent to fully clean the snorkel. For a more thorough cleansing, perhaps for a snorkel that has been sitting in the garage all year, soak the snorkel for up to 30 minutes in a bucket of warm water and a tablespoon of bleach. Afterward, rinse thoroughly in warm water and allow the snorkel to air dry.

Masks. Proper mask maintenance can be a little more difficult because you don’t want to scrub too hard and scratch the mask. Most masks will come with care instructions, so you should follow those instructions first. Sometimes certain silicone-based cleaning solutions are recommended to clean a mask, and these can be purchased at sporting goods stores or dive shops. If you don’t have the proper cleaning solution, you can use warm water and dish detergent, but do not use any brushes or abrasive sponges. Ensure that you remove all debris, dirt, sand and salt from the mask. You should also make sure that there is no sunblock residue left on the mask. Afterward, dry with a soft cloth or towel. If you have one, keep your mask in its case to keep it clean and prevent scratching.

Fins. Fins are probably the easiest piece of Bahamas snorkeling gear to clean. You can rinse them in freshwater or let them soak in a bucket of warm, soapy water. Dish detergent can be used for this as well. Make sure to clean out any debris with a soft sponge or soft-bristled toothbrush (scrub lightly!).

How do you dry the inside of a snorkel?

Put it in the snorkel. And it will absorb all the water inside of it. It’s clean and it should be dry by tomorrow. If you just leave it out with the paper towel it should all be dry.

How do you clean a Finis snorkel?

About once a month, (depending on usage) you can also submerge your snorkel in hot soapy water with a few drops of bleach and rinse with fresh water. It is also safe to run the snorkel, without the head bracket, through a wash in the top rack of the dishwasher.

How do you whiten a snorkel?

Snorkel. The snorkel is particularly important, as it needs to be kept clear and free of holes for maximum breathing ease. To keep your snorkel clean and bacteria-free, you can use one of two methods. You can wash the snorkel in a bucket of fresh water and dish detergent, rinsing it clean under fresh water, or you can soak it in a bucket of diluted bleach for 30 minutes and then rinse under running water. Let the snorkel air dry and then store in a cool, dry place.

Fins. Fins can be cleaned in a bucket of water, using dish detergent to scrub them inside and out with your hands. Be sure to clear out undersea debris like shell bits and sand, as these can be very sharp.

Keep your gear in tip-top shape after exciting Key West snorkeling tours by cleaning off immediately and storing properly. Taking good care of your snorkeling equipment will keep it looking and functioning like new much longer.

What are the two methods of clearing your snorkel?

The blast clear is the most popular method. This involves blowing out through the snorkel to force the water out through the top. If your snorkel has a purge valve, water will also exit through the purge valve below the mouthpiece.

Another method, called the displacement clear, can be used with snorkels not equipped with a purge valve. The displacement clear begins while you are still underwater. As you begin to surface, look straight up and exhale a small amount of air into the snorkel. As you ascend, the air will expand and displace the water. By the time you reach the surface, most if not all of the water will be cleared from the snorkel.

How To Use Your Snorkelling Fins. Once you have your fins on, walk backward or sideways to the waters edge. Although it is humorous to see people walking forward with their fins, it is strongly recommended that it not be done as you might break the blade and will be purchasing another pair quickly.

Once in the water, avoid using your hands to help propel you through the water. The best place for your hands is to place them behind you in the small of your back or straight out in front of you, it serves as a reminder on not using them to propel you through the water. Doing so will actually slow you down by creating more resistance. Instead let your fins do their job.

How to clean the inside of a snorkel?

• Mold and bacteria are the most common in snorkels. You must prevent growth in the snorkel tube. It can be a health hazard to breathe that in!
• This process is very similar to the mask cleaning procedure, but it is hard to reach the inside of the tube without a specific tool. The key differences are hotter water and soaking the snorkel tube longer.
• Rinse your mask with fresh water as soon as possible to remove any debris and saltwater. Check all the pieces and little nooks!
• Soak your snorkeling mask in warm water with mild dish soap or detergent. You could even use vinegar and water.
• Soak the snorkel in the solution for about 5-10 minutes.
• To scrub away any remaining debris, you could use a toothbrush. A toothbrush will be the best for getting inside the breathing tube.
• Rinse thoroughly with fresh water.
• Dry with a soft towel, then let air dry completely away from sunlight.
• Store the snorkel tube in a breathable bag in a cool, dry place away from sunlight.

• Rinse your fins with fresh water as soon as possible to remove any debris or saltwater. Make sure to clean out the foot pockets!
• Soak your fins in a bucket of warm soapy water.
• Scrub the fins with a soft sponge to clean out any remaining debris.
• Rinse thoroughly with fresh water.
• Dry with a soft towel, then let air dry completely away from sunlight. Make sure to dry the foot pockets!
• To keep the blades of the fins in good shape, store the fins by laying them down or hanging them up away from sunlight.

If your equipment shows signs of corrosion, soak it in equal parts vinegar and water. After soaking for a few minutes, rinse everything thoroughly with fresh water. Make sure to rinse all the vinegar off!

How long does a snorkel last underwater?

Conclusion. How long you can snorkel underwater with a full face snorkel mask depends on a number of factors, the quality and fit of your face mask, the weather conditions, currents & swell, your snorkelling experience, how comfortable you are in the water and your overall fitness level. In most cases, we don’t recommend diving underwater for any more than 2 minutes with a full face snorkel. Even if you are an experienced snorkeler who is going out in perfect conditions, we don’t recommend diving for more than 2 minutes. Remember, snorkels are designed to be used floating above the water, with only limited time to be spent actually underwater.

Passionate about the ocean & its beauty, John has been a passionate Snorkeler for over 10 years. Educating people on snorkelling techniques and equipment.

How to clear a snorkel?

If you get a little bit of water in your snorkel. And it makes a gurgling sound you still may be able to get little sips of air by filtering the air out with your tongue carefully. And slowly.